Structural analysis estimate flow
We would like to introduce the estimate flow for structural analysis.
1．3D data to analyze
If yes：Please provide data such as STEP/IGS.
If not：We can also create 3D from drawings, DXF data, etc.
▼
2．3D data to analyze
If modification is necessary:：Simplification/avoidance of interference is necessary.
Our company can handle this.
If no modification is necessary：Go straight to condition settings.
▼
3．Confirm conditions
Select strength analysis or eigenvalue analysis.
Constraint conditions (screw fixation, contact, clearance, etc.)
External force conditions (location, load, etc.)
Constraint conditions (screw fixation, contact, clearance, etc.)
External force conditions (location, load, etc.)
▼
4．Material information
If there is：Information on the following 6 items is required.
Required：Young's modulus [MPa], Poisson's ratio, specific gravity [g/cm3]
not required：Yield strength [MPa], tensile strength [N/mm2], coefficient of thermal expansion [cm/cm/℃(x10^-5)]
If there is none：Can be set under general conditions.
In special cases, it may be necessary to provide it.
If there is none：Can be set under general conditions.
In special cases, it may be necessary to provide it.
We will provide you with an estimate/delivery date based on the above items.